Skip to main content

Step 1 of 18: Copy the Landing Door and Edit Its Meta Data

PL4.1: Copy a similar Landing Door and edit its Meta Data as well as Key Parameters

Written by Alexandra Göttert

This article is part of a strict, sequential step-by-step tutorial for building a landing door, a car door, their door assignment, door fixings, fixing groups, door jambs, and jamb wallopenings. Follow the steps in order — each later step builds on the result of the one before it.

Prerequisites

  • DigiPara Liftdesigner and DigiPara Liftdesigner Datamanager are installed, with write access to the DigiPara BIM Library data pool you want to extend.

Steps

1.) Find a similar landing door and note its manufacturer and RID. In DigiPara Liftdesigner, find a landing door close to what you want to build. Note its unique RID number and its manufacturer / BIM Library — both are needed to find the same record in the Datamanager.

2.) Copy the landing door in DigiPara Liftdesigner Datamanager. Select the matching landing door record and use the copy function. The new component is copied with all parameters and values into your manufacturer module. Step through the 3-step copy process to see the result in your module.

Once the process is complete, click on CLOSE & OPEN COPY.

(If you haven't defined any libraries of your own yet, you can use 75:LD-Developer for practice purposes.)

3.) Edit the meta data: description. In Edit Mode, add a new, specific description for the copied landing door. Open a new table tab to save the new content in the database. Confirm the result in the DigiPara BIM Library tree.

4.) Copy and paste data rows with the complete existing content. To create additional door widths, select an existing row and use Ctrl+C / Ctrl+V to populate the data table with the existing content—this saves you from having to re-enter the information manually.

5.) Edit the meta data: door widths - DD_DW. Define the new selectable door widths—in this example: 2100, 2200, 2300. Verify the result by checking how the width options are displayed in LiftDesigner after you have replaced the components in your Liftdesigner project.

Make sure that the edit symbol at the beginning of the line has disappeared; otherwise, your new content has not been saved.

Result

A new, independent landing door record exists in the DigiPara BIM Library, with its own description and a defined set of selectable door widths.

Next Step

Did this answer your question?