Skip to main content

Step 6 of 18: Copy the Car Door and Edit Its Meta Data

PL4.6: Copy a similar Car Door and edit its Meta Data as well as Key Parameters

Written by Alexandra Göttert

Prerequisites

  • The landing door is finished and saved.

Steps

1.) Find a similar car door and note its manufacturer and RID. In DigiPara Liftdesigner, find the car door with DD_RID: 22 (the one used as the example for this tutorial), and note its manufacturer / BIM Library.

2.) Copy the car door in DigiPara Liftdesigner Datamanager. Copy the matching record into your manufacturer module. Step through the 3-step copy process to see the result.

Once the process is complete, click on CLOSE & OPEN COPY.

(If you haven't defined any libraries of your own yet, you can use 75:LD-Developer for practice purposes - same as landing door)

3.) Edit the meta data: description, and copy/paste data rows. Add a new, specific description for the copied car door, saving via a new table tab. To create additional door widths - similar to the landing door, select an existing row and use Ctrl+C / Ctrl+V to populate the data table with the existing content.

Make 3 copies.

4.) Edit the meta data: door widths - DD_DW. Define the new selectable door widths—in this example: 2100, 2200, 2300.

Result

A new, independent car door record exists in the DigiPara BIM Library, with its own description and defined door widths.

Next Step

Did this answer your question?