Prerequisites
You can configure machine beams and a self-constructed gear base.
Steps
Preparation: create the practice project
1.) Create and save the practice project. Using the Shaft Wizard, create a project with:
3 floors, typical floor-to-floor distance 3000 mm
Consider travel: No; Create building floor levels: No
Traction elevator 1:1; 13 persons / 1000 kg, 1 m/s
Drive location in the shaft head (MRL)
Car roping direct, lateral guided car frames only
Without counterweight safety gear; counterweight roping direct
Counterweight left
Sheet templates LD Installation Drawing and LD Typical Views For Your Elevator
Car width 1600 mm, car depth 1400 mm
Entrances front on all floors, right on the top floor
Save it as LDTrainingSampleA2_05.ld3.
Lateral guided gear base
2.) Understand the change. The machine moves from machine beams to a mounting between the guide rails.
3.) Switch off the default beam and choose a lateral gear base. Select a Lateral Gear Base Construction Unit.
4.) Select and align the machine. Use the Gearing properties.
5.) Customize the pulley diameter. Set a user-defined diameter.
Result
The machine is mounted on a lateral guided gear base construction between the guide rails, aligned, and given a user-defined pulley diameter.
Next Step