Skip to main content

Step 6 of 8: Create Luminous, Rough, and Glossy Surfaces

EL5.6: Cabin Design 3D Visualization

Written by Alexandra Göttert

Prerequisites

  • You've given the cabin floor an individual surface in the 3D Object Settings docking window and adjusted its Diffuse color and Texture settings.

Steps

Create a luminous surface

Luminous surfaces glow but don't illuminate other objects — for example, COP buttons. In this example, the COP button E is framed by a green light.

1.) Select the profile that frames button E. Set the Selection Mode to Select profiles, and make sure Show Profiles is active in the Breadcrumb. Then select the profile framing button E.

2.) Select a color and set it as emission. Select a RAL color — for example, RAL 6038 — and select the Emission option to define the color of the luminous surface.

3.) Switch back to selecting components. Set the Selection Mode back to Select components — otherwise you can't select components directly.

Create a rough-looking surface

A bump map is used to design textures with height differences within the surface structure.

4.) Select an individual surface texture and a bump map.

5.) Set the bump strength. Optionally, change the bump map while keeping the same texture.

Create highlights on a curved surface

Specular defines the color of the reflection of a light source. Shininess determines how blurred that reflection becomes.

6.) Try different Specular and Shininess settings on a handrail. Compare these setups:

Setup

Result

1 - Bright Specular, low Shininess

Wide, bright highlights

2 - Dark Specular, low Shininess

Wide, not very bright highlights

3 - Specular completely black

No highlights

4 - Colored Specular

Colored highlights

Result

You can make profiles glow (e.g. COP button frames), give surfaces a rough structure with bump maps, and control highlights on curved surfaces such as handrails.

Next Step

Did this answer your question?