Skip to main content

Set Up BIM Properties for a Component

Manage all Component Parameters that are included in a BIM Export from DigiPara Liftdesigner.

Written by Alexandra Göttert

Use the Component BIM Properties docking window to control which component parameters are included when you export a BIM model from DigiPara Liftdesigner. You can switch BIM properties on for a whole component type or for a single object, adjust the prefilled values, and choose which Autodesk® Revit® family type the component is exported as.

Note: Changing or entering values in this window does not change the model geometry. It only changes the information attached to the component.

Prerequisites

  • A project is open in DigiPara Liftdesigner.

  • The BIM properties you want to use are selected in the Project BIM Settings window. The Component BIM Properties window only shows the properties you selected there.

  • The Component BIM Properties docking window is open.

Steps

  1. Open Component BIM Properties.
    On the Export ribbon tab, in the BIM Exports group, click Component BIM Properties.

  2. Select the component in your project. For example a Landing Door.
    ​

  3. Choose how the BIM properties apply. At the top of the Component BIM Properties window, under BIM Properties, choose one of these options:

    • by Type (for example by Type: LDXLandingDoor) – the properties apply to all objects of this component type.

    • Enable for selected component – the properties apply only to the selected object.

    • Disable for selected component – the properties are switched off for the selected object only.
      ​

    This is especially useful for list components such as doors: you can activate the properties for a single door or for all doors in the list.
    ​

  4. Review the BIM values. The available properties depend on the Object Type of the selected component. They are grouped into these sections:

    • Autodesk® Revit® – Revit Standard Parameters such as Assembly Code, Description, Manufacturer, Model, OmniClass Number and Type Comments. A separate group holds the Revit Standard Parameters for IFC Export (Revit 2023 and higher).

    • DigiPara® – DigiPara parameters such as DigiPara.LDXType, DigiPara.RevitTargetName, DigiPara.RevitTypeName, DigiPara.IfcExportAs, DigiPara.IfcExportType, DigiPara.IfcParent, DigiPara.IfcFills and DigiPara.IfcAssignsTo.

    • IFC4 Standard Properties


    ​

  5. Edit a value, if needed. Many values are filled in automatically. To change one, click the pencil icon next to the value.
    ​

  6. Choose the Revit family type. Under Create Revit families based on, select which Revit family type is used when the component is exported:

    • By Document Default – uses the project default (Metric Generic Model).

    • Metric Generic Model (recommended) – use this for sectional views of imported models.

    • Metric Specialty Equipment – use this for escalator exports.

    • Metric Generic Model floor based


    ​

Result

The properties you set are attached to the component and carried into your BIM export. To check how they appear after import, see Parameter import in Autodesk® Revit® and Parameter import in IFC Viewer.

Did this answer your question?