Skip to main content

Add Drawings to Your Project

Select your project's drawings manually from the sheet templates in your data pool — either while creating a new elevator project, or later by adding a sheet to an existing one.

Written by Sabine Bunese

What you need

  • An elevator project — underway in the Shaft Wizard, or already created

Steps

  1. Reach the sheet template step.
    In the Shaft Wizard's last step, the list shows the sheet templates available in your data pool's sheets directory (e.g. C:\ProgramData\DigiPara\DCC\DataPool\sheets\*.*).

  2. Choose a suitable drawing template from the list.
    Pick individuall sheets — check each drawing sheet you want to add to the project or select all at once.

  3. Click Finish to close the Shaft Wizard and load your chosen sheet(s) into the project.
    ​

TIPP: Adding a drawing later? Outside the wizard, open the Sheet ribbon tab and click Add Sheet, then choose a sheet template the same way. This loads sheets into an existing project one or more at a time, without going through the wizard again.

Related Articles
Did this answer your question?