DESIGNATION | SYMPTOM | CAUSE | RESOLUTION | IMPORTANT |
Shaft center line too long | The shaft center line was rendering too long in views that combined symbolic representation with a visible box. | The center line calculation was not correctly accounting for where the symbolic view ended and the visible box began. | The fix corrects how the two modes interact when determining line extents. No action required. |
|
Shaft dimensions not shortening | When shaft dimensions were dragged to the opposite side of a vertical section view, the dimension lines did not shorten to reflect the new position. |
| The dimension extension line length adapts to the dimension side at the view frame. | The fix required adding additional extension points to the dimension logic. As a result, some dimensions that were previously not appearing at all (because their points were being treated as outside the visible box) will now become visible. This is expected behavior, not a new issue. |
Car operation panels 3 and 4 not initializing | Car Operation Panels 3 and 4 were not being initialized from the duty tables, which meant they did not appear in the property grid when the COP count was set to include them. |
| All COPs are now initialized consistently. If you set the COP count to 3 or 4, all panels appear in the property grid as expected. |
|