Skip to main content

Step 4 of 18: Reload the Landing Door and Check Results

PL3.4: Reload and check the results in Liftdesigner

Written by Alexandra Göttert

Prerequisites

  • Understood what each of the three key 3D parameters of the shaft door controls, and assigned new values ​​to them.

Steps

1.) Reload your edited landing door in DigiPara Liftdesigner. Reload the component so you can check the new landing door dimensions you filled in as parameters in the database.

You can easily check the new values ​​in the Data tree or directly on the drawing.

If you do not see the values ​​you just entered in the Datamanager, please check the Datamanager again to ensure the new content has been saved—the edit symbol should no longer be visible.

Result

The landing door's new dimensions are visible in Liftdesigner, and ready to hold the new profiles you'll design next.

Next Step

Did this answer your question?