This begins a full practical example — a steel shaft — that puts Additional Objects to use.
Prerequisites
Basic knowledge of Additional Objects.
Steps
1.) Create the steel shaft practice project. Using the Shaft Wizard, create a project with:
5 floors, typical floor-to-floor distance 3000 mm
Consider travel: No; Create building floor levels: No
Traction elevator, 2:1 roping
13 persons / 1000 kg, 1 m/s
Machine room: Top
Car roping: 2 pulleys below, without CW safety gear
Counterweight roping: 1 pulley top, counterweight right
Sheet templates: not necessary
Car size: width 1600 mm, depth 1400 mm
Entrances: front on all floors, rear on the first and last level
Individual floor-to-floor distances: Pit 1200 mm; E1 2900 mm; E2 3000 mm; E3 3000 mm; E4 3800 mm
Save the project as LDTrainingSteelShaft.ld3.
2.) Prepare your view frames. In the existing work area, prepare Plan, View from Left, and 3D View frames. Switch off any components not required for this exercise.
Result
The steel shaft practice project exists, saved and with its view frames prepared for the additional-objects work in the following steps.
Next Step