Skip to main content

Step 9 of 9: Practice: Select and Customize a Door Jamb

A1.9: Practical Example

Written by Alexandra Göttert

This practice combines component selection, exchange, measuring, extended settings, and grouping.

Prerequisites

  • You can export drawings and images, and the practice project LDTrainingSample.ld3 is fully configured.

Steps

Preparation: create the practice project

1.) Create and save the practice project. Using the Shaft Wizard, create a project with:

  • 5 floors, typical floor-to-floor distance 3000 mm

  • Consider travel: No; Create building floor levels: No

  • Traction elevator 2:1

  • 13 persons / 1000 kg, 1 m/s

  • Machine room, below, left

  • Car roping 2 pulleys below, with CW safety gear

  • Counterweight roping 1 pulley top, counterweight left

  • Sheet templates LD Installation Drawing and LD Typical Views For Your Elevator

  • Car width 1600 mm, car depth 1400 mm

  • Entrances front on all floors, rear entrance first and last level

  • Pit 1200 mm, E1 2900 mm, E2 3000 mm, E3 3000 mm, E4 3800 mm

  • Save it as LDTrainingSample_02.ld3.

Select and exchange the jamb

2.) Select the additional door jamb. Select the additional door jamb for the front entrance via the Breadcrumb docking window.

3.) Change the jamb type. Via the Component Navigator, change it to Wall-covering jamb and transom panel up to ceiling.

4.) Save the jamb as a favorite. Components that are hard to find in the Breadcrumb can be saved under Favorites — for all existing and new projects.

Measure and customize

5.) Measure a distance. Activate the Measure command, click near the first edge, hold Ctrl and click near the second edge, then release Ctrl. The result appears in the bottom right-hand corner of the program. Deactivate the line style if needed.

6.) Set a user-defined jamb design. Set User defined design to Yes and change the extended jamb settings using WT (wall thickness) and CH (ceiling height).

7.) Set the jamb option to full height. Select Full height. The jamb settings are adopted automatically for all floors.

Adjust individual floors

8.) Make one jamb different. Via the jamb of the respective floor, change the grouping to "This jamb is different."

9.) Adjust the door opening height individually. Edit the corresponding door opening height for that floor.

10.) Adjust the ceiling heights and check the result. Adjust ceiling heights via the Group and Shaft Configurator. Check the result in the view frame Entrance Front Detail Outside of the LD Installation Drawing sheet template.

11.) Change the color. BIM model colors can be adjusted via the corresponding property option.

Result

The front entrance has a wall-covering jamb with transom panel up to the ceiling, configured at full height for all floors, with an individual door opening height on one floor — and you've practiced the Breadcrumb, Favorites, Measure, and Grouping functions along the way.

Tutorial complete

This was the final step of the A1 DigiPara Liftdesigner Fundamentals tutorial. You've learned how data pools and the Poolmanager work, created your first elevator with the Shaft Wizard, found your way around the user interface, docking windows, and ribbon, worked with components, grouping, and dimensions, configured floor levels, exported drawings and images, and practiced it all on a door jamb. The natural next module is A2 – Elevator Design Fundamentals.

Related Video Tutorial

Did this answer your question?