This article is part of a sequential step-by-step tutorial covering view frames and section planes, special view types, sheets and sheet templates, annotations, the Data tree and project references, External$'s, external blocks (DWGs), title blocks and drawing borders, and a final practice exercise.
Prerequisites
DigiPara Liftdesigner installed.
You can edit DWG files.
Steps
Create the practice elevator project. Using the Shaft Wizard, create a project with:
5 floors, typical floor-to-floor distance 3000 mm
Consider travel: No; Create building floor levels: No
Traction elevator, 2:1 roping
13 persons / 1000 kg, 1 m/s, with CW safety gear
Machine room: Below / left
Car roping: 2 pulleys below
Counterweight roping: left, 1 rope pulley top
Sheet templates: LD Installation Drawing, LD Typical Views For Your Elevator
Car size: width 1600 mm, depth 1400 mm
Entrances: front on all floors, rear on the first and last level
Individual floor-to-floor distances: Pit 1200 mm; E1 2900 mm; E2 3000 mm; E3 3000 mm; E4 3800 mm
Save it under the file name LDTrainingSample.ld3.
Result
A practice elevator project exists with the exact configuration needed for the view frame, sheet, annotation, and project reference exercises in the following steps.
Next Step
Related Video Tutorial