Skip to main content

Step 2 of 8: Customize the Ceiling

EL5.2: Car Ceiling Configuration

Written by Alexandra Göttert

Prerequisites

  • Car Design is activated in the Cabin Configurator with the Steel Cabin Design (C-shaped panels), and the CabinApprovalDrawing sheet is loaded.

Steps

1.) Select the ceiling. Select the cabin component Ceiling. You can select it in different ways — the properties window is the same in each case.

2.) Compare the ceiling lighting types. The ceiling can be lit with downlights or with a light cover.

3.) Set the ceiling height and thickness. In the ceiling properties, set the decorative ceiling height and the ceiling thickness. 

Note: The dimension of the car ceiling itself (Shaft0.Car.CEILING) is changed in the properties after selecting it in the view frame.

4.) Set up the ceiling frame. Under the ceiling frame properties, set the Frame Clearance and the Frame width.

5.) Change the ceiling panel arrangement. Set Column count to 3 and Row count to 3. 

6.) Arrange the lights and change their type. Set Type to Squared, Row count to 3, Column count to 3, and Angle (global) to 45.

7.) Activate the trap door. Activate the Trap door (emergency exit) below the ceiling.

8.) Select and adjust the trap door. Select the trap door (it has its own default properties window) and adjust its location and size.

Result

The ceiling has your chosen height, frame, a 3 × 3 panel arrangement, squared lights rotated by 45°, and an emergency trap door in the right place.

Next Step

Did this answer your question?