Prerequisites
The ceiling is customized: height and frame set, 3 × 3 panels, squared lights (3 × 3, 45°), and the trap door activated and positioned.
Steps
Floor
1.) Set the floor type and frame. Select the cabin floor and set the Floor type and the Floor frame in its properties.
2.) Reduce the floor panels to one panel. In the floor panel properties, set Column count to 1 and Row count to 1, and check DZ (floor thickness).
Walls
The components under the walls are the same for every wall; their status varies with the position of each wall. In this tutorial, you modify the Rear Wall.
3.) Disable the wall components you don't need. In the rear wall properties, clear the check mark for any component you want to disable: Mirrors, Hand Rails, Bumper Rails, Kick Plates, Emergency door, Seat.
4.) Set the panel arrangement. In the rear wall properties, set the panel arrangement (Panel arrangement, Distribution starts, First panel starts) and the panel size (Default panel width, Maximum panel width extension). Compare with the default setting for the rear wall.
5.) Adjust mirrors, hand rails, bumper rails, and kick plates. Select each component under the rear wall and review its properties, starting from the default settings.
Note: The Emergency door and Seat always appear inactive in the standard Liftdesigner cabin design.
Result
The floor consists of a single panel with the floor type and frame you selected, and the rear wall has the panel arrangement and wall components you need.











