Prerequisites
The floor is reduced to one panel, and the rear wall's panel arrangement and components (mirrors, hand rails, bumper rails, kick plates) are set.
Steps
1.) Deactivate the COPs you don't need. In the Cabin Configurator, deactivate COP 3 and COP 4.
2.) Select the car operating panel. Select the cabin component Car Operating Panel and review the default settings for COP 1.
3.) Add the Kronenberg COPs to your pool. The COP type used in this tutorial comes from the manufacturer module Kronenberg. If it isn't in your pool yet:
Close all other DigiPara applications, then open the Poolmanager.
Check the manufacturer modules via Check for updates.
Select and apply the Legacy Product Libraries, which include the Kronenberg module.
Close the Poolmanager and restart DigiPara Liftdesigner.
4.) Select a different COP type. Select the COP type Kronenberg → COP_EN81-70_UTRE.
5.) Change the COP properties. In the COP properties, change the layout to two rows, then adjust the remaining car operating panel properties and the Number & Location of the COPs.
Result
The cabin has only the COPs you need, using the Kronenberg COP_EN81-70_UTRE type with two rows, positioned where you want them.







