This starts a tutorial on the Cabin Configurator and 3D visualization in DigiPara Liftdesigner: activating a cabin design, customizing ceiling, floor, walls, and car operating panel, and creating photorealistic visualizations with surfaces, scene settings, lighting, rendering, and image export. Follow the steps in order.
Prerequisites
DigiPara Liftdesigner is installed, and an elevator project created with the Shaft Wizard is open.
Basic DigiPara Liftdesigner knowledge (module A1 – DigiPara Liftdesigner Fundamentals), including working with the Poolmanager.
Steps
The Cabin Configurator lets you manage and control all cabin components in one central dialog.
1.) Open the Cabin Configurator and activate the car design. Select the Cabin Configurator ribbon tab, then activate Car Design by adding a check mark.
2.) Select a predefined cabin design. Choose a cabin design template from the DigiPara Liftdesigner library — for example, Panorama Cabin or Steel Cabin. For this tutorial, select Steel Cabin Design with C-shaped panels.
3.) Check the cabin approval drawing. Once the cabin setup is done, the sheet template CabinApprovalDrawing is loaded automatically.
4.) Review the component state. The Cabin Configurator shows the active main components and sub-components of the cabin. The relevant components and sub-components are generated automatically each time.
Result
The car design is active with the Steel Cabin Design, the cabin approval drawing is loaded, and you can see which cabin components and sub-components are active.




