Skip to main content

Change the Level of Development (LOD)

Choose how detailed the elevator is in your Revit model: LOD 100, LOD 200 or LOD 300.

Written by Sabine Bunese

Choose how detailed the elevator is in your Revit model. A lower LOD keeps the model light; a higher LOD shows every component.

LOD

What you get in Revit

LOD 100

The shaft only

LOD 200

The shaft, the cabin and the doors

LOD 300

All components, for example rails, brackets, counterweight and machine

Prerequisites

  • You are signed in to EAO in Revit.

  • The elevator group is in the add-in panel.

Steps

  1. On the Add-Ins tab, click LOD 100, LOD 200 or LOD 300. The active LOD is highlighted on the ribbon.

  2. In the add-in panel, click Update for the group. Update Progress opens. The add-in deletes the group's families and loads them again at the new LOD.

  3. When the progress bar shows 100 %, click Close.

Result

The elevator in your Revit model has the new level of detail.

NOTE: The LOD you choose is also used for every later update, for example after you configure the group.

Did this answer your question?