Skip to main content

Configure an Elevator Group in Revit

Change an elevator group after you've created it and rebuild it in Revit.

Written by Sabine Bunese

Prerequisites

  • You are signed in to EAO in Revit.

  • The elevator group is in the add-in panel.

Steps

  1. In the add-in panel, click Configure next to the group. The online configurator opens.

  2. Make your changes. The sections work as in Elevatorarchitect Online.

  3. Choose how to finish:

    • Update — saves the changes and rebuilds the group in Revit. Use this when the Revit model should show the change now.

    • Save and close — saves the changes in EAO only. The Revit model stays as it is until you click Update for the group in the panel.

  4. If you clicked Update, wait until Update Progress shows 100 %, then click Close.

Result

The group has the new settings in EAO. After an update, the Revit model shows them too: the add-in has replaced the group's families.

NOTE: The floor list in STOPS shows the Revit levels marked as Building Story. To add or remove floors, change the levels in Revit. To change the main floor, use Building on the ribbon.

Did this answer your question?