Skip to main content

Add a Family Prefix to an Elevator Group

Put a prefix in front of the family names of an elevator group, so you can find them in the Project Browser.

Written by Sabine Bunese

That way you can tell in the Project Browser which families belong to which group.

Prerequisites

  • You are signed in to EAO in Revit.

  • The elevator group is in the add-in panel.

Steps

  1. In the add-in panel, click the name of the group to unfold its settings.

  2. In Family Prefix (Optional), type the prefix. End it with a separator such as _ or -. The add-in doesn't add a separator.

  3. Click outside the field, then click Update below Location in Building. Update Progress opens, and the add-in loads the group's families again with the new names.

  4. When the progress bar shows 100 %, click Close.

Result

In the Project Browser, under Families › Generic Models, the group's families start with your prefix.

Did this answer your question?