Skip to main content

The Escalator Configurator at a Glance

What you see in the escalator configurator: group settings, unit cards, requirements, pending updates and the BIM model.

Written by Sabine Bunese

When you open an escalator project — from its tile or straight after the wizard — EAO opens the escalator configurator. It is built like the elevator editor: the settings on the left, the BIM model on the right.

What you see

Area

What it holds

Breadcrumb

Your path to the project. The three dots after the project name open Modify (rename) and Download .ld3.

Toolbar

Focus graphic widens the viewer. The two chevrons expand or collapse all sections. The zoom buttons scale the whole page.

Catalog

The catalog the project uses, and CHANGE CATALOG.

Group settings

REQUIREMENTS, ARRANGEMENT, PARAMETERS and FLOORS — valid for the whole installation.

Unit cards

One card per unit, below the group settings, with the values each unit has on its own (truss lengths).

BIM model

The sheet list, the viewer and Export.

For debugging purposes

Below the viewer: the .ld3 file, the escalator logs and a debug recording, for support requests.

Each section of the group settings shows a short summary in its header. You can read the configuration with every section collapsed.

Requirements

REQUIREMENTS lists every filter the chosen model has to meet, grouped by where it comes from:

Group

Filters

Site filter

Sales region, seismic zone and unit system of the site

Building filter

Building type

Escalator group filter

The catalog the project is limited to

Model filter

Travel (or horizontal length), inclination, step width, speed

A green tick means the model meets the filter. A red warning marks the filter that fails. The filters after it are greyed out because they weren't evaluated.

Changes wait for Update Model

Building an escalator through the reference model takes time, so a change doesn't reach the model by itself. Everything you change on the left is first a pending change:

  • A PENDING UPDATE label appears on the card you changed and on the BIM model.

  • The viewer is greyed out and its controls are inactive, because it still shows the previous model. The sheet list and Export are inactive too.

  • Update Model at the bottom of the left column builds the model again with the new values.

  • Cancel discards every pending change.

When the group is on hold

If the model no longer meets the requirements, EAO puts the group on hold. A red banner appears above the configurator, the section that causes it is marked red, and the breadcrumb shows a warning triangle. No 2D, 3D, BIM or export is generated until the issue is resolved.

Did this answer your question?