Same pattern as the pit detail in the previous step, applied to the head detail.
Prerequisites
The pit vertical section for CWT_L is finished and saved.
Steps
1.) Create a new vertical section for the head. On the CWT_L project, create a new vertical section, change its description to "Vertical Section Head CWT_L", and set its view frame type, component visibility, and dimensions.
2.) Modify the new vertical section. Delete the car and the car/counterweight ghost, and add extended dimensions for the CWT guide rails and bracket.
3.) Define rules for the vertical detail section. Create a new rule-based detail section covering both the Y-max/min and Z-max/min directions.
For the Y-direction, the reference point is the shaft base point — for example
LD("Shaft0.W_1").For the Z-direction, the reference point is the last floor; simple mathematical calculations can be used here.
4.) Save your own vertical section. Save the new vertical section inside the MyDST-Viewframe folder, as VerticalSectionHead_CWT_L.
Result
A rule-based vertical section for the head detail exists for the CWT-left project, matching the pit detail's approach but referencing the last floor instead of the first.