Skip to main content

Step 3 of 9: Use the Start Screen and Create Your First Elevator with the Shaft Wizard

A1.3: First Steps with DigiPara Liftdesigner - Shaft Wizard

Written by Alexandra Göttert

You get to know the start screen and walk through the Shaft Wizard step by step, entering the values for the practice project used throughout the rest of this tutorial.

Prerequisites

  • An active data pool is set up, with the manufacturer libraries you need.

Steps

Start screen and licensing

1.) Get to know the start screen. It gives you: Create a new elevator, Create a new escalator, Open existing projects, quick access to recent projects, the newest DigiPara blog articles, community connections, licensing information, and Update DigiPara BIM libraries.

2.) Check your licensing information. It shows your current contract status and your computer data.

Shaft Wizard

3.) Understand where the wizard's solutions come from. The standard elevator arrangements offered by the Shaft Wizard are stored in Duty Tables in the DigiPara Liftdesigner geometry BIM database. The major elevator size and the selected components are read from these duty table records. Click Create a new elevator to start the wizard.

4.) Wizard step 1 — enter the project information. Provide project-specific information; it can later be referenced in title blocks and external drawing blocks. The project units specify the units used in the drawing (this training uses metric; imperial projects work the same way).

5.) Wizard step 2 — enter the building data. Set the number of floors, the floor-to-floor distance (these values affect the entrances on all floors), whether to consider the travel from the database or set it manually, whether to create building floor levels, and whether to activate a wall finish for each entrance side. For the practice project enter: 5 floors, typical floor-to-floor distance 3000 mm, Consider travel No, Create building floor levels No.

6.) Wizard step 3 — define the main requirements. Specify the elevator manufacturer (if downloaded from the DigiPara Cloud), the general elevator type, the minimum payload (as number of passengers or a fixed payload), and the minimum speed. You can define entrances in advance here, or add and adjust them later in the project. For the practice project enter: traction elevator 2:1, 13 persons / 1000 kg, 1 m/s.

7.) Wizard step 4 — set the elevator characteristics. Choose the drive location, machine room location, car and counterweight roping, counterweight location, and the filters Lateral Guided Car Frames Only and With Counterweight Safety Gear Only. Different car sizes may be available for the configuration — use Select another solution to pick one. For the practice project enter: machine room Below / left; car roping 2 pulleys below, with CW safety gear; counterweight roping 1 pulley top, counterweight left.

Different car sizes can also be available in the database for the elevator project defined up to this point.

8.) Wizard step 5 — load sheet templates. Select default sheet templates or a predefined sheet group for your elevator; the list can also be extended with your own templates. For the practice project select LD Installation Drawing and LD Typical Views For Your Elevator.

Finish the practice project

9.) Check the result and adjust the car size. Your first elevator project is complete. The Work area is a default sheet that shows a plan view by default. Set the car width to 1600 mm and the car depth to 1400 mm.

10.) Save the project. Save it as LDTrainingSample.ld3.

Result

You know the start screen and licensing information, have walked through all five Shaft Wizard steps, and the practice project LDTrainingSample.ld3 exists with the required configuration and car size.

Next Step

Related Video Tutorial

Did this answer your question?