Skip to main content

Step 10 of 13: Use the Rule Editor to Drive Separate Assembly Parts

EL4.10: Control your CAD Model using custom Formulas

Written by Alexandra Göttert

In some CAD models a parameter isn't controlled in the assembly itself but by a separate part. In the example, the rail bracket assembly width is controlled by a separate part.

DP-SW RB02 0000 00.SLDASM

Prerequisites

  • You have carried out both previous automation variants.

  • You have a fundamental understanding of how the automation process works.

Steps

1.) Add the controlling part to the Assign Automation dialog. In addition to the CAD model assembly, the controlling part is also needed in the Assign Automation dialog.

2.) Add an assignment record for the part parameter. Add a new assignment record and choose the part's CAD parameter from the Target CAD Parameter list.

3.) Define the source value with the Rule Editor. In the Source Value column, open the Rule Editor and create an equation from DigiPara Liftdesigner PG-Parameters and fixed values that defines the complete rail bracket assembly width — for example: RB_DBG + 2*GD_H_1 + 180 (distance between guides + 2 × guide rail + fixed value) Check and save the rule before you close the Rule Editor.

4.) Move the mapped part above the assembly. Move the mapped part up (IX 0) above the assembly. Otherwise the automation only changes the separate part and doesn't affect the assembly.

Result

The width of the whole rail bracket assembly follows the distance between guides and the guide rail size of your project, calculated by a rule.

Next Step

Did this answer your question?