Skip to main content

Create an Escalator or Moving-Walk Project

Add an escalator, an inclined moving walk or a horizontal moving walk to a building with the five-step wizard.

Written by Sabine Bunese

Add an escalator, an inclined moving walk or a horizontal moving walk to a building. A five-step wizard asks what you are building, where it goes and which values matter to you, and then shows the brands that can deliver it.

Prerequisites

  • You are signed in to EAO

  • The site and building exist, with correct floor heights

  • At least one escalator catalog is available to you

Start the wizard

  1. Open the building. Escalators and moving walks have their own section, Escalators & Moving Walks, below the elevator groups.

  2. Click New Escalator Project.
    ​

TIP: When you create a new building, the last page of the building wizard offers the same choice: click New Project and pick Escalator instead of Elevator.

The column on the left of the wizard shows where the new project will sit: site, building and the project itself. Use the numbered pager at the bottom to move between the steps.

Steps

  1. Enter a name.
    The default is My Escalator. The name appears in the left column as you type.

  2. Click next.

  3. Choose the type: Escalator, Inclined moving walk or Horizontal moving walk. One project is one kind of installation.

  4. Choose the arrangement:

    • Escalator and inclined moving walk: Single, Parallel, Criss-Cross or Criss-Cross-Shifted

    • Horizontal moving walk: Single or Parallel

    Single gives one unit, every other arrangement two.

  5. Escalator or inclined moving walk: Choose the lower landing.

    The upper landing is always the next floor up. The travel is the floor-to-floor height between them, taken from the building.

  6. Horizontal moving walk: Choose the floor.
    Enter the horizontal length in millimetres.

  7. Set the parameters.
    ​Escalator and inclined moving walk: inclination, step width, speed and horizontal step run (the number of flat steps)
    ​Horizontal moving walk: step width and speed

  8. Choose the brand.
    Click Select on the brand you want. The brand moves to Selected brand on the left, and finish becomes active.

  9. Click finish.

Result: The project is created in the building and the escalator configurator opens. The building header counts both kinds of project.

NOTE: The top floor isn't in the list, because an escalator connects two adjacent floors.

Did this answer your question?