Skip to main content

Create an Elevator Group

Add an elevator group to a building: requirements, stops and elevator brand.

Written by Sabine Bunese

An elevator group is one or more elevators in a building that share the same requirements. You enter the main requirements and the stops, then pick an elevator catalog. EAO then suggests a matching elevator, which you can refine in the elevator editor.

Prerequisites

  • You are signed in to EAO

  • You have a building with floors, or you are in the NEW BUILDING wizard

  • You know the required payload and speed, or are fine with the lowest available values

Steps

  1. Open the NEW ELEVATOR PROJECT wizard: at the end of the building wizard, click New Elevator Project, or click the NEW ELEVATOR PROJECT tile on the building page. The wizard has four steps.

  2. In ELEVATOR GROUP NAME, enter a name, then click next.

  3. Under MAIN REQUIREMENTS, set:

    • NUMBER OF CARS: 1–8. With more than one car, the cars can be organized into one or two banks.

    • PAYLOAD (KG): select a value. The default is Any (Lowest). Click the operator button in front of the list to switch between ≥ (at least this value) and = (exactly this value).

    • SPEED (M/S): select a value. The default is Any (Slowest). The operator button works the same way.

  4. Under ENTRANCES SIDES, click the layout you need: front entrances only, or front and rear entrances.

  5. Click next.

  6. Under STOPS & SERVICES, check the floors. All floors of the building are listed. Clear the FRONT check box for each floor the elevator should not stop at. The top and bottom floors are always stops. Use the lists on these two floors to change the travel range.

  7. Click next.

  8. Under ELEVATOR BRAND, choose a catalog:

    1. Find the brand under PREFERRED ELEVATOR BRANDS or MORE ELEVATOR BRANDS. To add a brand to your preferred brands, click its star.

    2. Click the arrow next to a model (for example MRL-Class-I) to see its car size and payload.

    3. Point at the brand card and click Select. The button changes to Selected, and the brand appears under SELECTED BRAND on the left.

  9. Click finish. The button only becomes active after you select a model.

Result

EAO creates the elevator group and opens it in the elevator editor. The breadcrumb shows My Projects › site › building › elevator group. The editor shows the selected catalog and the suggested elevator (model, payload, cabin, counterweight, entrances, door front, shaft, stops), plus the BIM MODEL live preview with 2D Plan selected.

Did this answer your question?