Skip to main content

Change the Settings of a Project

Reopen the wizard of a site, building, elevator or escalator group with Modify and change what you entered.

Written by Sabine Bunese

Change what you entered when you created a site, building or elevator group. Modify reopens the wizard that created the element, with your current values filled in.

Prerequisites

  • You are signed in to EAO

  • The site, building or elevator group already exists

Open the wizard

You can open Modify in two ways:

  • From a card: on My Projects, a site page or a building page, point at the card and click its ··· button. Choose Modify.

  • From the breadcrumb: open the site, building or elevator group. In the breadcrumb, click the ··· button on the current chip and choose Modify.

Change a site

The MODIFY SITE wizard has the same two steps as the wizard that created the site.

  1. In step 1, change the SITE NAME or the SITE IMAGE.

  2. Click next.

  3. In step 2, change the SEISMIC ZONE, the SITE LOCATION or the MODEL UNIT.

  4. Click finish.

Result: EAO saves your changes. The site card shows the new name and image.

Change a building

The building wizard opens with both steps: name, type and image, then the floor list.

  1. In step 1, change the BUILDING NAME, the BUILDING TYPE or the image.

  2. Click next.

  3. In step 2, change the floors. See Create a Building and Define Its Floors for the floor list.

  4. Click finish.

Result: EAO saves your changes to the building.

NOTE: If the floors came from an IFC file, the option to enter floors by hand reads Edit manually (removes the IFC file). Choosing it removes the IFC file from the building.

Change an elevator group

For an elevator group, MODIFY ELEVATOR GROUP only shows the ELEVATOR GROUP NAME.

  1. Change the name.

  2. Click finish.

Result: The elevator group has the new name.

NOTE: To change cars, payload, speed, entrances or stops, open the elevator group in the elevator editor.

Did this answer your question?