Skip to main content

Manage the Elevators in a Group

Add, rename, reorder and delete elevators in a group, and split the group into two banks.

Written by Sabine Bunese

An elevator group can hold up to eight elevators. In the elevator editor you can add elevators, rename them, change their order, delete them, and split the group into two banks that face each other across a hall.

Prerequisites

  • You are signed in to EAO

  • The elevator group is open in the elevator editor

Add an elevator

The new elevator starts as a copy of the one you add it from, so you only have to adapt it if necessary.

  1. Find the elevator you want to copy.

  2. Click the + button above its column.

  3. Wait a few seconds. A new elevator appears, named with the next free number.

  4. Change the settings that should be different for the new elevator, for example the counterweight side or the entrances.

Result: The group has one more elevator. It has the same model, payload, cabin, counterweight, entrances, door front, shaft and stops as the elevator you copied.

Rename an elevator

EAO names the elevators E0, E1, E2 and so on. Give them names that match your building plans, so everyone recognizes them.

  1. Click the elevator's name at the top of its column.

  2. Select the text and type the new name.

  3. Press Tab or click outside the field.

Result: The column shows the new name. Long names are cut off in the column, but the full name is saved.

Change the order of the elevators

Between two elevators, click the arrow button to swap them.

Result: The two elevators change places in the editor and in the drawing.

Delete an elevator

Click the bin button above the elevator's column.

Result: The elevator is removed from the group in the editor and in the drawing..

Split the group into two banks

Use two banks when the elevators face each other across a hall.

  1. Click the gear icon next to BANK 1. The Elevator bank settings open.

  2. Switch on Split into 2 Banks.

  3. Under Split behind, choose the elevator of the first bank. The elevators after it form the second bank. With Automatically, EAO decides where to split.

  4. In Across the hall distance (mm), enter the distance between the two banks.

  5. Under Align Bank 1 and Bank 2, choose Left, Center or Right.

  6. Optional: in Offset (mm), enter how far the second bank is shifted sideways.

  7. Click Apply.

Result: The editor shows BANK 1 and BANK 2, each with its own gear icon and an Add elevator button. The 2D plan shows both banks facing each other, with the hall distance and the offset as dimensions.

To go back to one bank, open the bank settings again and switch off Split into 2 Banks.

Did this answer your question?