Skip to main content

Change Special Shaft Dimensions

Switch an elevator to Special to change car, door and shaft dimensions beyond the catalog.

Written by Sabine Bunese

By default, all dimensions of an elevator come from the catalog model. When the shaft or the car has to differ from the catalog, for example in an existing building, switch the elevator to Special. You can then change dimensions beyond the catalog.

Prerequisites

  • You are signed in to EAO

  • The elevator group is open in the elevator editor

  • The catalog model is as close as possible to what you need.

Switch an elevator to Special

Next to the elevator's name, click Special.

Result: The label above the column changes from Catalog to Special. The sections now show the current dimensions in tables with a pencil icon, and a new section, MANUAL DEVIATIONS, appears at the bottom. On the building page, the group card shows a SPECIAL badge.

How the dimensions depend on each other

In Special mode you don't type the shaft size directly. The shaft follows the car, the doors and the clearances:

  • A wider or deeper car moves the shaft dimension with it, and the shaft head stays above the car height.

  • The door sits in the car front: it can't be wider or taller than the car, and its door package is part of the shaft depth.

  • Shaft width and shaft depth follow from the car, the doors and the clearances. What you edit are the clearances.

Change the car and door dimensions

  1. Unfold CABIN.
    Click the pencil icon next to Car Width, Car Depth or Car Height and enter the new value.

  2. Unfold ENTRANCES.
    Click the pencil icon next to Door Width or Door Height and enter the new value.

  3. Optional: next to Door type, click Configure… to change the door type, or select Pocket Installation.

Result: The shaft and the drawing follow the new dimensions.

NOTE: In Special mode, the counterweight location is fixed and can't be changed. Only Safety gear on counterweight can be switched.

Change the shaft head and pit

  1. Unfold SHAFT.
    The table shows Shaft Width, Shaft Depth, Shaft head and Shaft pit.

  2. Click the pencil icon next to Shaft head or Shaft pit and enter the new value.

Change the clearances in the drawing

  1. In the BIM MODEL panel, select 2D Plan.

  2. Click the arrow button above the drawing to switch to pick mode.

  3. Click a dimension in the drawing, for example the shaft width (SW). A window shows how the value is made up. For the shaft width: left clearance + counterweight package + car platform + right clearance.

  4. Change the clearances you need.

  5. Click Apply.

Result: The shaft dimension and the drawing are updated.

NOTE: Pick mode only works for elevators set to Special.

Check your deviations

Unfold MANUAL DEVIATIONS to see which values differ from the catalog model. As long as you haven't changed anything, it reads "No manual deviations yet — every value of this unit still matches its catalog model."

Did this answer your question?